BASIC INFORMATION ABOUT YOUR INSTALLATION

1) Choose a place that you will enjoy making Passion. Some couple use their Passion Swing to make Passion for hours. This can be anywhere in your home Next to your bed or in a corner of the bedroom or even the middle of the living room or den. If you'll enjoy it there, put your new sex furniture right there!

3) The Passion Swing is designed for 8 foot ceilings. If your ceiling is over 8 feet you will need a chain to connect to the supplied eye screw and the swings' "hook". The chain should be rated for over 500-pound test.

TOOLS AND SMALL ITEMS YOU WILL NEED FOR INSTALLATION

1) To locating the hidden rafters use your 3 finish nails or a stud finder. It helps to know if the rafters or joist are located 16" or 24" apart. You can look in the attic or ceiling crawl space to find out the direction and distance these rafters are apart. One way to locate them, if you don’t have nails or stud finder, is to tap lightly on the ceiling. Listening to the differences between a hollow sound (no rafter or joist) and a solid, sharper sound (a rafter or a joist). Don’t get discouraged: they’re up there!

2) To make sure you are on the center of the joist or rafter, hammer a small nail at the selected spot. Then hammer a second nail ½" to the left and another ½" to the right of the first one. Make sure all the nails are hitting solid wood. This should give you the center of the rater or joist.

3) Drill a starter hole using your ¼" drill bit half way between the two outside nails. This hole should be about 1½ - 2" deep.

4) Remove all the nails. 

5) Screw in the eye screw all the way. If it is hard to turn this is a good sign! If it turns easily it's not in solid wood. So try again! When it gets too hard to turn, put the screw driver through the hole in the eye screw and use as a lever to finish turning all the way up to the ceiling.

PUTTING  EYE SCREW in an OPEN BEAM CEILING
You can also install your Passion Swing in a room with an open beam ceiling or in an archway. Simply screw the eye screw into the center of a solid beam or the archway. Each offers good support

The Passion Swing must be hung using the attached "hook"

Other Creative Use Options

Using a strong rope, webbing or chain

How about from a tree in the yard or in the forest, or maybe a beam in the garage
or using the Passion Stand near your hot tub or pool
or ................

FINISHING and TESTING YOUR INSTALLATION

1) Place the "hook" attached to your Passion Swing into the eye screw.

2) Press each end of the spreader bar firmly into the webbing pocket near the top adjusting buckles. It adds support for many exciting positions, keeps the entire front of your body available and helps keep the swing much more comfortable.

3) The 2 foot supports are already attached to the spreader bar. They are  slipped into the center of the bar. You can adjust these to any position for use later. Your Passion Swing sex furniture should now look like the pictures on this page.

4) Using the lever on the 2 upper buckles, lower the entire swing to a few inches off the floor.

5) Grab the spreader bar or upper straps and carefully stand on the edge of the swing. You will be off the ground just a few inches and able to move easily around.

6) Everything should now be properly installed and secure.

7) Use the 8 buckles (shown on the right) to adjust your love swing to your desired height. For your first new love making experience, a good starting height is so the seat height is about level with the man's penis. When your partner get in, it will naturally adjust to the correct position. (see the how to use section for further suggestions on positions)

8) NOW.... Enjoy It!  Enjoy It!  Enjoy It!